ZEB Cam for Revo - GitUp G3 Camera Reset

Procedure

If you're not sure which ZEB Cam version you have, check out this article first: Which ZEB Cam version do I have?

1. Remove the camera retaining screw using a 4mm hex key.
   
2. Remove the camera from the frame.
   
3. Remove the SD card from the camera.
4. Power on the camera by pressing the Power/Mode button on the front of the camera.
5. Ensure the camera is set to video mode. Short press the Power/Mode button on the front of the camera to cycle between Video mode, Camera mode and Pre-view mode.
   
6. Enter the Camera settings by touching the Camera Settings icon on the touch screen.
   
7. Swipe left to page 4 of the camera settings.
   
8. Select the Reset Option to reset the camera to default settings.
9. Make the following camera settings:
    

   Camera settings
   System Settings	Page	Changes to Default
   Car DVR	1	ON
   Ext power	2	CHARGE
   USB	2	MASS STORAGE
   Lock	3	OFF
   Auto Off	3	3 minutes
   Set Time	4	Current date/time

10. Swipe down to exit the Camera settings.
11. Enter the Video Settings by touching the Video Settings icon on the touch screen.
    
12. Make the following video settings (note – the camera settings in step 9 must be made before making the video settings):
     

    Set up the video settings
    Video Settings	Page	Changes to Default
    Resolution	1	1440P4:3
    Loop	1	OFF
    Microphone	4	OFF
    Stamp	4	OFF

13. Swipe down to exit the Video Settings page.
14. Power off the camera by long pressing the Power/Mode button.
15. Install the SD card in the camera.
16. Test the camera:
    1. Power on the camera by long pressing the Power/Mode button.
    2. After powering on the camera should automatically start to record.
    3. Stop the recoding the long pressing the Power/Mode button. The camera should turn off.
17. Refit the camera in the frame and refit the camera retaining screw with a 4mm hex key.