ZEB Horizon ZEB Cam Firefly 8SE reset
Overview
This article explains how to reset the ZEB Cam for ZEB Horizon - Firefly model 8SE.
Note: Please check your camera model first to make sure you are following the correct procedure.
Procedure
- Remove the camera from the scan head by unscrewing the 4 retaining screws using T20 Torx screwdriver.
- Remove the camera from the frame.
- Remove the lens protection cowling from the front of the camera (simply pull forwards and off).
- Remove the fixing screw in the base of the camera using a 4mm hex key.
- Remove the single screw on the back face of the camera using a T10 Torx screwdriver.
- Slide the back cover down and off the camera frame.
- Slide the cable boot down and out of the camera frame.
- Push the camera and cable assembly backwards and out of the camera frame.
- Disconnect the cable assembly from the camera mini USB B socket.
- Remove the SD card from the camera.
- Power on the camera by pressing the Power/Mode button on the front of the camera.
- Ensure the camera is set to video mode. Short press the Power/Mode button on the front of the camera to cycle between Video mode and Camera mode.
- Enter the camera settings menu page by touching the settings icon on the touch screen.
- Select the Camera settings and the swipe down to the Default Setting option.
- Select the Default Setting option and the touch the Tick box to accept this selection. The camera will reset then briefly power off and back on.
- Go back to the Camera settings page again by touching the Setting icon on the touch screen.
- On the Video Settings sub-page make the following:
| Video settings | |
|---|---|
| Video settings | Changes to default |
| Video Resolution | 4K (3840x2160) 30 FPS |
| Microphone Volume | OFF |
- On the Camera Settings sub-page make the following:
| Camera Settings | |
|---|---|
| Camera Settings | Changes to Default |
| LCD brightness | LOW (to save battery life) |
| Auto Shutdown | 3 Min |
| Screen Off | OFF |
| Time Setup | Change as Required |
| Language | Change as Required |
- Press the Power/Mode button to exit the settings page.
- Long press the Power/Mode button to power the camera off.
- Refit the camera in the frame.
- Reconnect the cable assembly to the camera mini USB B socket.
- Push the camera and cable assembly into the camera frame.
- Push the cable boot up into the camera frame.
- Slide the back cover up into place.
- Refit the single screw on the back face of the camera using a T10 Torx screwdriver.
- Refit the fixing screw in the base of the camera using a 4mm hex key.
- Refit the lens protection cowling from the front of the camera.
- Install the SD card in the camera.
- Test the camera by connecting the camera cable to the ZEB Horizon scan head and initiating a scan. The camera should start recording when the scan starts (scan head rotations starts).
- Refit the scanner frame to the scan head using the 4 M4 x 10 screws.